Quick look at the Powerspark Ignition Kit K1 & K1PP Lucas 22D6 & 25D6 6 Cylinder

The Powerspark 22D6 & 25D6 Lucas 6 Cylinder distributor ignition kit and powermax red rotor arm are a superb pairing giving increased durability and performance. Usually fitted to Aston Martins DB5, DB6 & DBS, Austin Healey 3000, Daimler 2.8l – 5.3l, Jaguar E-type & XJ, Mg MGC & MGC GT, & Triumph six cylinder engines please refer to distributor casting number to ensure correct fitment.

We recommend using silicon HT leads with electronic ignition ONLY
Using copper HT leads without resistors can cause premature failures to any electronic ignition and this can void your warranty.

Pre Installation Checks

Please ensure you have a negative earth car if you have the negative earth kit and vice versa.

  • If your car has a Ballast ignition you are running a Ballast ignition coil such as a Lucas DLB110
  • Ensure there is a good earth to the distributor, ignition kit and ignition coil.
  • The Powerspark kit will operate on 6 volt or 12 volt Applications.
  • Make sure any Live wires are to the correct side of the coil e.g. auto choke

Installing the Ignition Kit

  1. Remove the points and condenser from the distributor.
  2. Check earth wire to ensure it is in good condition and not frayed or broken (replace if needed).
  3. Place trigger ring over the central shaft ensuring a tight fitment do not force the trigger on.
  4. Install the ignition kit using your old screw fixing point
  5. Run the wire around the back of the kit making sure they won’t snag when the distributor advances.
  6. Connect the Ignition kit to the ignition coil ensuring you follow the instructions provided or relevant instructions, same side as the ignition feed Live.

Negative Earth Wiring:
Powerspark red wire goes to Positive (+ VE, SW, or 15) on ignition coil.
Powerspark Black wire goes to Negative (- VE, CB, or 1) on ignition coil.
1 Switchable live to the Positive (+ VE, SW, or 15) side of the coil only.

Click to purchase a negative earth kit
Add to Cart

Positive Earth Wiring:
Powerspark white wire goes to ignition feed taken off the ignition coil and left off.
Powerspark black wire taken to coil negative.
Coil positive terminal taken to earth.

Click to purchase a positive earth kit
Add to Cart


25d4 Points Distributor

25d electronic distributor inside

Please Contact Powerspark Ignition LTD if you have any questions
Call : 01527 889453
Email : sales@simonbbc.com