Pre Installation Checks
We recommend using silicon HT leads with electronic ignition ONLY
Using copper HT leads without resistors can cause premature failures to any electronic ignition and this can void your warranty.
Pre Installation Checks
- Please ensure you have a negative earth car if you have the negative earth kit and vice versa.
- If your car has a Ballast ignition you are running a Ballast ignition coil such as a Lucas DLB110
- Ensure there is a good earth to the distributor, ignition kit and ignition coil.
- The Powerspark kit will operate on 6 volt or 12 volt Applications.
- Make sure any Live wires are to the correct side of the coil e.g. auto choke
- Ensure you have a Single set of points in your distributor.
- For Twin Points with non Vacuum advance only
- This is a Full Base plate replacement ignition kit
Installing the Ignition Kit
- Remove the twin points including the the plate they are attached to from the distributor.
- Install the New plate with the ignition kit fitted into the distributor
- Place trigger ring over the central shaft ensuring a tight fitment do not force the trigger on.
- Run the wire around the back of the kit making sure they won’t snag when the distributor shaft spins.
- Make sure your live ignition feed to the coil is on the positive terminal only.
- Connect the Ignition kit to the ignition coil ensuring the
Powerspark red wire goes to Positive (+ VE, SW, or 15) on ignition coil.
Powerspark Black wire goes to Negative (- VE, CB, or 1) on ignition coil.
Please Contact Powerspark Ignition LTD if you have any questions or are unsure about anything
Call : 01527 889453
Email : sales@simonbbc.com